FLOWQUIP
MINING AND INDUSTRIAL
FLOWQUIP MINING AND INDUSTRIAL
Flushing of hydraulic and lubrication oil systems is employed to ensure that new rotating and hydraulic equipment will start up and operate as designed, significantly reducing the potential for premature failure. Maintenance and downtime on equipment can be minimized by performing an effective system cleaning during commissioning and following maintenance and repair services. Any facility that has a low tolerance for equipment failure will find this service key to their preventative maintenance program.
Removal of harmful contaminants is key to keeping your rotating and
hydraulic equipment operating at peak performance.
Industrial Flushing & Filter Services
Services
Cooling System Flushing
Diesel Polishing
Equipment Sales
Equipment Rentals
Fluid Filtration
Line Flushing
Oil Purification
Pipe Pickling
Reservoir Filling
Water & Varnish Removal
.jpeg)
Some of the equipment we work on
Electric Motor Drives
Equipment Reservoirs
Diesel Generators
Gas Turbines
Hydraulic Power Units
Lube Oil Systems
Reciprocating Engines
Storage Tanks
Solar Turbines
Atlas Copco
Industrial Flushing & Filtration Services
OIL ANALYSIS IN THE FIELD
Reasons for Lube Oil Flushing
Flowquip uses Parker Hannifin’s icountPD which represents the most up-to-date technology in solid particle
contamination analysis. The icountPD is a compact, laser-based particle detector module that provides a solution to fluid management and contamination control.
The icountPD measures particle contamination continuously and updates the display, output
options and limit relay every second with a ISO Cleanliness Code. This unit does not perform a ‘one-off’ test. This means
that even if the Measurement Period is set to 60 seconds, the display, output and limit relay all
report the presence of dirt in the oil in just a few seconds – it does not wait until the end of the
Measurement Period before reporting the result.
Patch Testing
Oil cleanliness can be visually analyzed in the field without waiting for lab results.
The test provides the opportunity to see the type, concentration, and actual size of particulate contamination
inside the system during the flushing process.
Patch testing is an ISO 4406 approved form of oil testing.
Products Offered
-
VACUUM DEHYDRATION OIL PURIFICATION SYSTEMS (VDOPS) OIL PURIFIER
-
LOW VISCOSITY FILTER CART
-
VARNISH REMOVAL SYSTEMS
-
FILTER SKIDS - PORTABLE
-
HIGH-FLOW FILTRATION SYSTEMS
-
FILTER CARTS - PORTABLE
-
LOW-FLOW FILTRATION SYSTEMS
-
FILTER HOUSINGS
-
FUEL FILTRATION AND COALESCER SYSTEMS
-
FLUID ANALYSIS KIT
-
REPLACEMENT FILTER ELEMENTS
-
LUBE OIL COALESCER SYSTEM
-
BEARING LUBE OIL SYSTEMS
-
OFF AND ON SITE OIL COOLER FLUSHING
HOT OIL FLUSHING AND FILTER SKID
HOT OIL FLUSHING ACE HEAT EXCHANGER
VARNISH REMOVAL SKID
VARNISH REMOVAL SKID
.jpeg)
LASER PARTICLE COUNTER
HOT OIL FLUSHING ACE HEAT EXCHANGER
HOT OIL FLUSHING LUBE OIL SYSTEM FOR CONE CRUSHER
FLUSHED OUT 19 LBS. OF COPPER SLAG FROM LUBE OIL SYSTEM
FLUSHED OUT LARGE PIECE OF GEAR FROM CONE CRUSHER LUBE OIL YSTEM
Reasons for Lube Oil Flushing
-
Newly Installed Systems
-
Preventative Maintenance
-
Contamination (Visible Particulate)
-
Oil Change Out (replacing old lube oil that is
discolored or scored) -
Excessive bearing wear
-
Sticky control activation
-
Catastrophes
